Posted - 23 Feb 2011 : 23:30:12
| From the P3 System Controller you can access device-specific parameters like:
- ON/OFF for the StatusLED on the back of the panel
- Brightness of the Display on the back of the panel (only on LC/LC+)
The following example shows some of the parameters you can access on LC/LC+ and EC series panels.
You can access these parameters on fixtures/panels which are configured (used on the canvas) or fixtures/panels which are just discovered.
Here I clicked the serial number of the EC-20 panel in the discovered devices pane to bring up its properties. The settings are listed at the bottom of the screen.
You can change a parameter by double-clicking the arrow behind it. Here I turn off the StatusLED on the back of the EC-20 panel.
You can also select multiple panels/fixtures at the same time using "ctrl+click". The screenshot below shows the selection of two LC2140+ panels.
Using this method you can change the paramaters for all selected fixtures at the same time, like turning off the displays on the back of the panels.